Discreet Carry Concepts Monoblock Gear Clip™ 1.5" *With DCC Logo*

• 2.73" OAL
• Fits over belts up to 1.5"
• (2) .220"H x .300"W horizontal slotted mounting holes will work with spacing that is .860" - 1.15" on center.
• Standard DMG/Cu finish: Color - DCC dark matte grey. Non reflective and resists corrosion very well
• Works with or without a belt.
  

• (2) Low profile 1/4” Chicago Screws brand combo screws with reusable thread patching (pre applied threadlocker)
• (2) steel washers
• (2) steel square nuts makes it easy to counter hold with a wrench or your fingers in tight areas
• Standard DMG/Cu finish on all components: Color - DCC dark matte grey. Non reflective and resists corrosion very well
• Once assembled, always double check clearances to ensure the nuts or screws will not contact your equipment before use
• The Monoblock is engineered to be mounted directly to the holster body or other solid surface. Recommended hardware configuration from top to bottom: Screw, steel washer, Monoblock clip, body of the holster. The nut is placed on the inside. For some applications, the metal washer can be placed behind the clip or may not be used at all. Please verify clearances to ensure the square nut is compatible with your specific holster brand and it is recessed enough to not protrude inside the holster body.

Care and maintenance: Our surface finish does not need much attention. If any light scratches or wear marks develop, we recommend a quick yet firm buff with WD40, but anything from vegetable oil to mineral oil to CLP to motor oil will work well. Just put a couple drops on your clip and rub it in vigorously using firm pressure with a lint free cloth. This will help keep it looking it's best cosmetically.